Set both of these values as well as minDistance to their max. Next, right click on the light’s maxDistance > Remap Slider Range and change the max value to 90,000. Remap the maximum intensity value if you need to. Avoid using too much linearAttenuation however as it will cause a lot of bloom. Set the brightness of the light using intensity and linearAttenuation. Also make sure to set its FOV to the maximum to cover as much area as This is roughly the color to mimic the sun, experiment around with whatever works for you. Set it’s color to roughly the color of the sun (can be any color, but for this guide I will be mimicking the sun) However, there are ways to work around these issues to create a parallel light such as the sun.įirst, create a new light and place it high in the sky where you would like your sun to be. SFM’s lights are limited by the fact that they are point lights, meaning that the light comes out of a single point in space. For the purposes of this guide, I will be using koth_lakeside to demonstrate. Once you are done with this open the map up in SFM. Use a – (instructions are included on their website).Find a dark version of the map on the SFM workshop (sometimes there aren’t any).Use the Hammer editor and remove the lights on the map.There are 3 ways to get a dark version of the map: This means either using toneMapScale (dont) or using a dark version of the map with no lights. Since you will be relighting the map, you need to be able to overwrite the existing lights on the map with your new ones. This works best on maps with no lighting.

Source filmmaker map